Printable View
<BLOCKQUOTE><font size="1" face="Verdana, Arial">quote:</font><HR>Originally posted by strng1dah:
i think jegs or summit or something like that sells 90degree or "U" bends of mandrel piping.
<HR></BLOCKQUOTE>
I think that's 180 degrees isn't it... http://www.hostboard.com/ubb/biggrin.gif
------------------
Donny
Import Specialty Automotive
(253) 473-2606
http://www.hostboard.com/ubb/tongue.gif
<BLOCKQUOTE><font size="1" face="Verdana, Arial">quote:</font><HR>Originally posted by Import Tuner:
I think that's 180 degrees isn't it... http://www.hostboard.com/ubb/biggrin.gif
<HR></BLOCKQUOTE>
my bad what I meant to say was:
I think jegs or summit or one of them sell 90 degree, as well as "U" bends(180degrees).
damn grammar police http://www.hostboard.com/ubb/biggrin.gif
------------------
2000 GSR [email protected]
<BLOCKQUOTE><font size="1" face="Verdana, Arial">quote:</font><HR>Originally posted by fastfour:
Waveoff, the other plot is an SI with an ITR manifold and cams.
Lundgren, definitely the larger diameter intake helps. I also got a new K&N to fit the larger pipe.
I will have it coated later this year to try to prevent the underhood air from heating it up. Any suggestions?
Zach<HR></BLOCKQUOTE>
Hey guy see you got the same one as Cisco http://www.hostboard.com/ubb/smile.gif I already talked to Donny about making one for me but I am holding off until I figure out if I am going to swap out my TB (Zip you get it yet???) Donny does some great work! Look in to getting it JetHot coated or something simular.
------------------
...Steven
Powered by Endyn
Tech Spec